Aluminum I-Beam Track
- 6063-T5 Extruded Aluminum Track
- Supplied in up to 20ft sections
- 1”w x 2-1/2”h
- Anodized Black
- Custom curves available
Cut Sheet
Single Carrier
- Neoprene-tired shielded ball bearing wheels riveted to formed steel body with swivel hook and trim chain
- Plastic glide strips for reduction in noise & friction
Cut Sheet
Master Carrier
- 2 Neoprene-tired shielded ball bearing wheel assemblies with swivel hook and trim chain pivot on formed steel body
- Supplied with 2 clamps for securing operating line
- 1 pair required for overlapping tracks
- Carrier load rating at 12” center spacing: 8lbs
Cut Sheet
Double End Pulley
- 4” Diameter Nylon sheaves grooved for 1/4” diameter rope with shielded ball bearings
- Steel housing clamps to track
- For use with bi-part and single draw track systems.
Cut Sheet
Single End Pulley
- 4” Diameter Nylon Sheave grooved for ¼” diameter rope with shielded ball bearings
- Steel housing clamps to track
- For use with bi-parting tracks.
Cut Sheet
Single End Pulley
- 4” Diameter Nylon Sheave grooved for ¼” diameter rope with shielded ball bearings
- Steel housing clamps to track
- For use with one-way draw tracks.
Cut Sheet
Clamp Hanger
- Formed steel brackets clamp to track
Adjusts for various positions
- Load rating for track varies based on install spacing
Cut Sheet
Splice
- Aluminum plates align and bolt top track sections together
- Track must be straight at joint.
Cut Sheet
Ceiling Hanger
- Steel plate mounts flush to ceiling
- Track clamps to bracket with offset clips
- Adjustable mounting for various locations
- Load rating for track varies based on install spacing
Cut Sheet
Outside Idler
- Formed steel bracket with single ball bearing pulley for guiding of operation cord
- Used along the outside of the single pulley end of track systems
Cut Sheet
Single Spindle
- Formed steel bracket with single ball bearing shaft for guiding of operation cord
- Used along the inside single pulley end of track systems
Cut Sheet
Double Spindle
- Formed steel housing contains two ball bearing guides for operating line to follow curve
- Mount to inside and outside of curve on double end pulley section of track for single and bi-parting draw systems.
Cut Sheet
Wall Mount Track Bracket
- Formed steel wall bracket for mounting of curtain track
- Universal design for mounting in two directions
- Mounting surface utilizes holes and slots for ease of installation
- Brackets are powder coated in black finish
- Load Rating: 150lbs
- Custom colors available
Cut Sheet
Low Pipe Track Bracket
- Creates easy 360 degree mounting of standard I-Beam track systems to 1-1/2” Pipe
- Primarily intend to attach to the lower pipe on Pipe Grid Systems.
- This arrangement allow for the bottom of curtain track systems to be installed just 2-7/8” below the hanging pipe
- Bracket provided in Black
Cut Sheet
Extended Pipe Track Bracket
- Creates easy 360 degree mounting of standard I-Beam track system to 1-1/2” Pipe.
- Primarily attaching to the upper pipe on Pipe Grid Systems.
- This arrangement allow for the bottom of curtain track systems to be installed just 4-3/4” below the hanging pipe
- Bracket provided in Black
Cut Sheet
Curtain Track Hanger
- Formed steel wall bracket for mounting of curtain track
- Mounting surface utilizes holes and slots for ease of installation
- Brackets are powder coated in black finish
Cut Sheet
Overlap Clamp
- Steel formed bracket to offset tracks for bi-part
- Black finish
Cut Sheet
